Rothenberger ROFUSE 400 TURBO Bedienungsanleitung Seite 29

The desired menu point can be selected using the two central up and down arrows and con-
firmed using the >arrow to the right<.
The >arrow to the left< allows one to leave this menu and navigate back to the Start screen.
Clock
Adjusting the date and time The date and time are displayed in the format dd.mm.yyyy hh:mm.
Select the number to be changed over the >arrow to the left< and >arrow to the right< but-
tons. Corrections can be made using the >+< and >-< buttons. The menu can be exited again
using the >arrow to the left<.
The clock is supplied with power by an internal battery so that this can also run after being dis-
connected from the mains power plug.
Language
Adjusting the language. Select the desired language using the >arrow upwards< and >arrow
downwards< buttons and confirm using the >OK< button.
Parameter
The password-protected area. Settings can be made on the device in this menu point which
have effects on the device properties and functions (e.g. welder code, scan site-code, traceabil-
ity, ...). Entries and functions can be enabled or disabled for the user and therefore sequences
prescribed at the construction site. The PIN code is pre-allocated on the works side with
"12345". Please alter the password as needed (see sub-menu point "Password"). The menu can
be left at any point using the >END< button.
Welder code
Entry of the welder code can be activated or deactivated here (for a description see Chapter
7.3). The status can be altered by pressing the >CHANGE< button.
ENGLISH 27