Temperature Unit (Temp. Unit); Measure Mode; Interface - Mettler Toledo Refracto 30P Bedienungsanleitung

Menu (menu)
Example
(measured) refractive index at 15°C (T
(measured) refractive index at 26°C (T
1.3334 – 1.3324
26 – 15
α x 1000 = 0,091; enter this value into the instrument.
5.3

Temperature unit (Temp. Unit)

Unit for displaying the temperature in °C or °F (selectable).
5.4

Measure Mode

Configuration of identification and method of data storage.
Sample Name
Mode
Labo
Field
Custom User-defined setting.
5.5

Interface

PRN Printer interface
Data transfer to the printer
Printer with serial interface and connected infrared adapter. Results are
formatted for output to a printer.
Transfer rate (baud rate), parity and stop and data bits must be config-
ured according to the peripheral device.
The following settings are required for the METTLER TOLEDO LC-P45
printer:
Baud rate
Parity
Stop bits
Data bits
RS Serial interface, data transfer to the PC via the infrared adapter.
Transfer rate (baud rate), parity and stop and data bits must be config-
ured as in the MiniTerm program, see Chapter 8.
IrDA Data transfer to the PC with the integrated IrDA interface in accordance
with protocol 1.20.
10
= 0.0000909
Sample identification.
A letter (A ... Z or space) can be set for the identification of
samples.
Method of data storage.
By pressing the ok/measure key the result is saved and trans-
ferred (printer, PC).
By pressing the ok/measure key the result is saved.
Memory in Save results.
Auto
Manu
Memory out Transfer result to PC or printer.
Auto
Manu
9600
none
1
8
): 1.3334
1
): 1.3324
2
Save result automatically.
Result saved by pressing the
ok/measure key.
Transfer result automatically.
Transfer result by pressing the
key.
METTLER TOLEDO Refracto 30P