Vehicle Settings; A) Setting The Camber - Reely ROAD Audi S5 Bedienungsanleitung



9. Vehicle Settings

a) Setting the Camber

The camber is the inclination of the wheel level as compared to the vertical.
Negative inclination
(Top wheel edge points inwards)
The setting of the wheel is exaggerated in the two figures in order to make the difference between nega-
tive and positive cambers more obvious.
The setting on the model vehicle should of course not be as extreme as shown! This not only leads to
uncontrollable driving behaviour, but also to very quick wearing away of the inner and outer tyre edges!
• A negative inclination of the front wheels increases the lateral cornering powers of the wheel when driving through
bends, the steering reacts more directly and steering forces are reduced. At the same time, the wheel is pushed onto
the axle leg in the direction of the axle. This stops axial bearing clearance, the driving behaviour is calmer.
• A negative inclination of the rear wheels reduces the tendency of the rear of the vehicle to swerve in bends.
• Setting a positive camber on the other hand reduces the cornering force of the wheels and should not be used.
Setting Front Axle Camber:
The camber is set by twisting the upper transverse link
(A).
Because the upper transverse link has a left and right
hand thread each, the transverse link does not need
to be dismantled for the camber to be adjusted.
There are several more suspension points (B) for the
upper transverse link at the damper bridge.
Depending on the assembly position, the wheel
camber changes when the wheel rebounds (e.g.
stronger camber when the wheel is pushed in).
The manufacturer has already picked the best
installation position. Therefore, do not attach the
transverse link to any other suspension point.
44
Positive inclination
(Top wheel edge points outwards)
B
A