Herunterladen Inhalt Inhalt Diese Seite drucken

C) Attaching Antenna Tube; Inserting Battery In Vehicle - Reely ROAD 23 10 72 Bedienungsanleitung

1:10 off-road buggy
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

c) Attaching Antenna Tube

• Release the tied up antenna cable of the vehicle.
Straighten the cable, by holding it at the end with two
fingers and by pulling it with two fingers of the other
hand several times into the direction of the receiver (do
not any apply force, don't pull cable on the receiver!).
• Now the antenna cable is to be pushed into the antenna
tube until it comes out at the other end again.
• Put the antenna tube into the place indicated on the pic-
ture on the right with an arrow.
Do not fold the cable, do not shorten it!
• If a rubber cap is included, it belongs on the end of the
antenna tube.
d) Inserting Battery in Vehicle
Take the holding bracket off, by pulling the clip out before. Afterwards the rechargeable battery pack
can be inserted (possibly a little tight).
Replace the holding bracket again and secure it with the clip.
The rechargeable battery pack must not yet be connected to the cruise control/receiver.
37

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

23 38 0123 37 6323 10 6723 15 63

Inhaltsverzeichnis