Troubleshooting - Reely ROAD Audi S5 Bedienungsanleitung


16.

Troubleshooting

Even though the model and the remote control system were built according to the state of the art, there may still be
malfunctions or errors. For this reason, we would like to give you some information on how to deal with possible
problems. Also observe the enclosed operating instructions for the remote control system!
 The model does not respond
• Is the vehicle drive battery or are the batteries/rechargeable batteries in the transmitter discharged?
• Did you switch on the transmitter first and then the speed controller? Correct: Always switch on the transmitter first
and then the speed controller!
• Is the drive battery connected to the speed controller correctly?
• Is the vehicle too far away? With a fully charged drive battery and fully charged batteries/rechargeable batteries in
the transmitter, the range should be 100 m and more. The range can be decreased by outside influences, such as
transmitters working on the same or an adjacent frequency (e.g. WLAN devices, bluetooth, etc.).
• Check the correct position of the speed controller and steering servo plugs in the receiver. If the plugs are twisted by
180°, the speed controller and steering servo will not work (if the plugs of speed controller and steering servo are
swapped, the throttle/brake lever will control the steering servo and the wheel will control the driving function).
• Programme the neutral position and full throttle positions for forward and reverse driving as described in chapter
10. a).
 The vehicle does not stop when the throttle/brake lever is released
• Adjust the driving function neutral position at the transmitter.
• Programme the neutral position and full throttle positions for forward and reverse driving as described in chapter
10. a).
 The vehicle becomes slower or the steering servo only shows weak or no responses
• The drive battery is weak or discharged.
The receiver power supply and thus also the power supply of the steering servo is achieved through the speed
controller BEC. Therefore, a weak or discharged drive battery will cause the receiver to no longer work properly.
Replace the drive battery with a new, fully charged one (before inserting a new drive battery, wait at least 5 - 10
minutes until motor and speed controller have cooled down sufficiently).
• The undervoltage recognition of the speed controller was activated (drive battery discharged); the red LED at the
speed controller flashes.
• The overtemperature protection of the speed controller was activated (speed controller too hot); the orange LED at
the speed controller flashes.
57