Tools And Aids - Reely ROAD Devastator R32 Bedienungsanleitung

Are more glow plugs necessary?
Glow plugs wear, especially during the running-in stage. Thus, we recommend that you always keep in store some glow plugs for replacement. There are glow
plugs with different thermal values; proper selection of the glow plug has a great influence on the driving performance. In the run-in stage, you should use a "cold"
glow plug for high-performance engines. After the run-in stage, you can change to a glow plug with medium thermal value.
Use glow plugs for RC cars only! A wrong glow plug, e.g. for 4-stroke model plane engines lets the motor run improperly and makes tuning more
difficult.
Our advice: Degrees of heat of glow plugs
• Standard glow plugs for fuels with nitro methane additive (approx. 5 %)
• Cold glow plugs for fuels with nitro methane additive (approx. 10 %)
• Super cold glow plugs for fuels with nitro methane additive (more than 10 %)
Installation/exchange of glow plugs
Requires a glow plug wrench (lug wrench SW 8, 9, 10 and 12).
Preheating the glow plug
A glow plug starter with rechargeable battery is placed on the glow plug and heats this so that the air-fuel mixture ignites and the engine starts. Once the engine
runs properly, the glow plug starter can be removed.
e) Tools and Aids
Before the start, you have to make and check a few basic settings as well as provide the necessary accessories and operating materials.
Go through the various points of the check list one by one; afterwards, your model is then ready to run.
Tools
• Socket wrench for the wheel nuts
• 5 mm and 5.5 mm flat spanners to set alignment and inclination
• 1.5 mm Allen key for the grub screws on the adjusting rings of the throttle/brake and steering linkages
• Phillips screwdriver
• Normal screwdriver for the throttle stop screw and the main nozzle needle
Auxiliary materials
• Cable clips
• Air filter oil
• "After Run" oil
38