Herunterladen Inhalt Inhalt Diese Seite drucken

Charging The Batteries - Reely ROAD Carbon Fighter Bedienungsanleitung

1:24 ep 4wd rtr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8 Slider „TH.REV" for reverse function of the drive
This inverts the response of the drive (forward/reverse) to operation of the lever (2).
9 Red power LED
The LED is lit when the transmitter is switched on.
10 Button „PAIR" for pairing function
This button is used for binding between transmitter and receiver, so that the vehicle reacts to the control functions
of the transmitter (see chapter 11).
11 Green LED for battery/rechargeable battery level
The LED is lit when the batteries/rechargeable batteries are sufficiently charged. The LED flashes when the
batteries/rechargeable batteries are weak.
12 On/off switch
This slider turns the transmitter on („I" position) or off („0" position). Never turn the transmitter off when the vehicle
is in operation!


8. Charging the Batteries

Observe chapter 6.
• The vehicle may be operated with 4 NiMH batteries type AA/mignon instead of 4 batteries.
The model is delivered without any rechargeable batteries. They must be purchased separately. We recommend
using NiMH batteries with the highest possible capacity (2000 mAh or more) to ensure a long driving time. NiMH
rechargeable batteries with low self-discharge are a good choice as well.
• The rechargeable batteries are usually delivered uncharged and must be charged. Before rechargeable battery
reach their maximum capacity, several complete discharge and charge cycles are necessary.
• Use a high-quality charger for single cells for charging. It usually has a quick-charging feature for rechargeable
batteries.
• Rechargeable batteries heat up when charged or discharged (driving the vehicle). Wait until the rechargeable batteries
have reached room temperature before charging them. The same applies after the charging procedure. Do not use
the rechargeable batteries in the vehicle until they have cooled down sufficiently after the charging process.
Due to the high power consumption of the vehicle and for cost reasons we recommend that you only use
rechargeable NiMH batteries. If you want to use conventional batteries in the vehicle nevertheless, only
use high-quality, fully charged alkaline batteries.
In case of excessive power withdrawal, the batteries will otherwise only deliver a relatively low output
voltage that may cause deactivation of the speed controller/receiver.
31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis