Select Outgoing Message Mode; Recording, Checking Or Deleting Outgoing Messages; Recording An Outgoing Message - switel DCT8572 Bedienungsanleitung

- Telephone Answering Machine -
13.3.2 Setting the volume on the answering machine
If the volume of the answering machine is too high or low when playing back
messages or listening-in to incoming calls, it can be adjusted to one of 3
levels.
+ or -
13.3.3 Delay taking the call
It is possible to set the number of times the telephone should ring before the
answering machine takes the calls. The number of rings can be set between
2 and 9. In addition, the toll-saver" setting is available to use the free
pre-remote access function (refer to Chapter 13.9.6).
A or C,
13.4

Select outgoing message mode

The answering machine is provided with two, pre-recorded outgoing
messages. A distinction is made between outgoing message with message
recording (OGM1) and outgoing message only (OGM2). If no other outgoing
message is recorded, the pre-recorded outgoing message is played
automatically. When the answering machine memory is full, it automatically
reverts to the outgoing message only (OGM2) message explaining to the
caller that messages cannot be left.
f
The outgoing message currently set is then played back.
13.5

Recording, checking or deleting outgoing messages

13.5.1

Recording an outgoing message

The outgoing message recorded can be maximally 2 minutes long. Select the
required outgoing message to be replaced by your own (refer to Chapter
13.4). The pre-recorded outgoing message with message recording (OGM1)
or outgoing message only (OGM2) is replaced by the outgoing message you
record. The pre-recorded outgoing message can be restored as necessary
(refer to Chapter 13.5.3).
c
Speak after the acoustic signal.
L, f
Adjust the volume
Press the button on the underside of the
base station for 2 seconds
Select setting and confirm
Change outgoing message mode
Press for 2 seconds
Speak your message and confirm
139