Remote Activation Of The Answering Machine; Free Of Charge Pre-Remote Access - switel DCT8572 Bedienungsanleitung

- Telephone Answering Machine -
13.9.5

Remote activation of the answering machine

The remote access feature enables the answering machine to be switched on
via any telephone which uses the tone dialling method.
M
*, M
If the security code is entered incorrectly three times, the line is
automatically disconnected.
9
Other functions can be executed via the remote access system
within the following 10 seconds. Refer to the table in Chapter
13.9.4.
Replace receiver
13.9.6

Free of charge pre-remote access

The free of charge, pre-remote access function can be used to determine
whether messages have been left on your answering machine without
accruing any telephone charges.
To do this, set the Delay taking calls" function to toll-saver". Refer to
Chapter 13.3.3.
When you subsequently call the answering machine while underway, the
answering machine responds as follows:
S If your call is taken after 2 rings, there are messages on the
answering machine.
S If no messages have been recorded, the call is not taken after 2
rings. Replace the receiver immediately because the call will be
taken after 5 rings. No telephone charges are necessary because
no connection has been made.
Dial your own phone number
Wait 10 rings, press during the outgoing
message and enter security code
Switch on the answering machine and select
the outgoing message mode
End remote access
143