Message Alert Signal; Setting The Volume; Listening In To Incoming Messages; Interrupting A Recording - switel D8525 Bedienungsanleitung

1. Press the
2. Use the
3. Press the
Note: You can check the setting at any time by briefly pressing the
7.1.5

Message alert signal

As soon as a new message has been recorded, the base station will emit a beep every minute to alert you that one
or more messages have been recorded during your absence.
This function can be switch on or off by briefly pressing the
the button is released, the current setting will be confirmed.
7.1.6

Setting the volume

The volume for message or memo playback and listening to incoming messages can be set between L1 and L5
using the and
7.1.7

Listening in to incoming messages

Normally, you can monitor incoming calls at the base station while they are being recorded.
This function can be switch on or off by briefly pressing the
button is released, the current setting will be confirmed.
7.1.8

Interrupting a recording

You can interrupt a message recording by taking the call via the handset. To do this, press the
handset. The answering machine switches off, and you can talk to the caller directly.
7.1.9

Recording, changing or deleting the greeting message

For your greeting message, you can use a pre-recorded English standard message, or you can record your own
message. If you have not recorded your own greeting, the caller will automatically hear the standard greeting. The
length of your own greeting message may not exceed 40 seconds.
Text of the pre-recorded standard greeting:
"Hello, your call cannot be taken at the moment. So please leave your message after the tone".
Recording your own greeting message
1. Press and hold the
2. Dictate your message after the beep
3. Once you have recorded your greeting, press the
Note: Even if you have recorded your own greeting, you can revert back to the pre-recorded greeting at any time.
For more information see Section 7.1.11.
7.1.10

Checking the current greeting message

You can check your greeting message at any time. Simply press the
message.
- Answering machine -
button on the base station for two seconds.
and buttons for setting the required number of rings between r2 and r7 or tS.
button again. The selected setting is repeated.
buttons.
button for two seconds.
button.
for button (the factory setting is Off). Once
button (the factory setting is On). Once the
button. You will hear your new greeting.
to listen to your current greeting
button at the
95