What To Do If - IKEA ANRÄTTA Handbuch

ENGLISH
4. Refit the upper edge: A click will indicate
correct positioning. Make sure the seal is
secure before refitting the door.
To replace the lamp
1. Disconnect the oven from the power
supply.

What to do if ...

Problem
The oven does not work.
The display shows the letter
"F" followed by a number
Before calling the Authorized Service
Centre:
1. See if you can solve the problem yourself
with the help of the suggestions given in
the "What to do if ..." table.
2. Switch the appliance off and back on
again it to see if the fault persists.
If after the above checks the fault still
occurs, contact IKEA Authorized Service
Centre.
Always specify:
• a brief description of the fault;
• the type and exact model of the oven;
If any repairs are required, please contact IKEA Authorized Service Centre (to guarantee
that original spare parts will be used and repairs carried out correctly).
Fig. 5
Possible cause
No presence of mains
electrical power.
The oven is not
connected to the
electrical supply.
Software problem
2. Unscrew the lamp cover (Fig. 5), replace
the lamp (see note for lamp type) and
screw the lamp cover back on.
3. Reconnect the oven to the power supply.
NOTE:
- Only use 25W/230 V type G9, T300°C
halogen lamps.
- The lamp used in the appliance is
specifically designed for electrical
appliances and it is not suitable
for household room illumination
(Commission Regulation (EC) No
244/2009).
- Lamps are available from IKEA
Authorized Service Centre.
Solution
Verify the presence of mains
electrical power.
Connect the oven to the
power supply.
Contact you nearest After-
sales Service Centre and
state the letter or number that
follows the letter "F"
• the service number (number after the
word Service on the rating plate),
located on the right hand edge of the
oven cavity (visible when the oven door
is open);
• your full address;
• your telephone number.
16