Siemens SIMATIC NET CP 1512 Installationsanleitung Seite 55

Trademarks
SIMATIC ® , SIMATIC NET ® , SINEC ® and SIMATIC NET Networking for Industry ® are
registered trademarks of Siemens AG.
Third parties using for their own purposes any other names in this document which refer
to trademarks might infringe upon the rights of the trademark owners.
Safety Instructions Regarding your Product
Before you use the product described here, read the safety instructions below thoroughly.
Qualified Personnel
Only qualified personnel should be allowed to install and work on this equipment.
Qualified persons are defined as persons who are authorized to commission, to ground,
and to tag circuits, equipment, and systems in accordance with established safety
practices and standards.
Correct Usage of Hardware Products
Please read the relevant Installation Instructions and adhere to the instructions regarding
the correct usage of hardware products.
Correct Usage of Software Products
Please note the following regarding the correct usage of software products:
Caution
This software may only be used for the applications described in the catalog or the
technical description, and only in connection with devices or software products from other
manufacturers which have been approved or recommended by Siemens.
Before you use the supplied sample programs or programs you have written yourself,
make certain that no injury to persons nor damage to equipment can result in your plant
or process.
Prior to Startup
Before putting the product into operation, note the following warning:
Caution
Prior to startup you must observe the instructions in the relevant documentation. For
ordering data of the documentation please refer to the catalogs or contact your local
SIEMENS representative.
CP 1512 Installation Instructions
C79000-N8974-C001-02
55