Cocraft TC180C-UK Bedienungsanleitung Seite 7

Assembly
Screw on the blade guard (4) if it is not already in place.
Use
Sawing tiles
1. Place the tile saw on a smooth and level surface.
2. Fill the water tray with clean water up to the "max level" mark. The correct water
level is stated on the blade guard and on the inside of the water tray.
3. Tilt the work table to the desired angle by loosening the adjusting screws (8).
Tighten the screws when
the tilt angle has been set.
4. Set the blade guard (4) so that a tile just fits between the guard and the table.
5. Think about how the task is to be performed. Set the parallel guide fence (2), it can
be mounted on either side of the blade. Set the fence to the same scale mark on
both ends of the table to ensure that it is parallel.
6. Adapt the parallel guide fence's handle (1) by turning it clockwise/anticlockwise
until you have the correct resistance and then tighten it so that it stays in place.
Measure, using a ruler or tape, the distance between the blade and the guide
fence to make sure that the cutting length will be correct.
7. Plug the mains lead into a 230 V wall outlet and turn the tile saw on by switching
the on/off switch (7) to I. Let the blade come up to full speed before beginning
to cut.
8. Feed the tile into the blade with a smooth and continuous motion. Use the parallel
fence as a guide.
9. Turn the motor off by switching the on/off switch to 0. Do not remove the pieces of
cut tile until the blade has completely stopped rotating.
Sawing at an angle of 45°
1. Place the tile saw on a smooth and level surface.
2. Fill the water tray with clean water up to the "max level" mark. The correct water
level is stated on the blade guard and on the inside of the water tray.
3. Adjust the level/tilt of the work table to the desired angle using the adjusting
screws (8). Tighten the screws when the tilt angle has been set.
4. Set the blade guard (4) so that a tile just fits between the guard and the table.
5. Think about how the task is to be performed. Set the parallel guide fence (2), it can
be mounted on either side of the blade. Set the fence to the same scale mark on
both sides.
7