Cocraft TC180C-UK Bedienungsanleitung Seite 3

• Wear suitable attire. Do not wear loose-fitting clothing or jewellery; they could
be caught in moving parts. Non-slip shoes are recommended for outdoor work.
Wear a hairnet or similar if you have long hair.
• Always use safetywear. Wear safety glasses. Use a dust mask or dust filter when
working in dusty environments.
• Use dust extractors. If the tool is equipped with or connected to a dust extractor/
collector, make sure that it is turned on and used correctly.
• Do not abuse the lead. Do not jerk the lead, grip the plug itself when disconnecting
the power. Make sure that the mains lead does not come into contact with heat,
oil, or sharp edges.
• Firmly secure the workpiece. If possible use vices or clamps to hold the workpiece
in place. This is much safer than holding the workpiece in one hand.
• Do not overreach. Make sure that you stand steady and balanced all times.
• Look after you tools. Make sure that they are clean and that the edges are sharp
for maximum effect and best results. Follow the manuals recommendations
regarding lubrication and replacement of accessories. Inspect the mains lead
regularly. If it is damaged it should be replaced by a qualified service technician.
Inspect all leads and cables regularly to check for any damage. Make sure that
the tile saw's handles and controls are clean, dry and free from oil and grease.
• Turn the power off. Pull out the plug and push in the emergency stop button before
servicing or changing any blades, drill bits, cutters or sanding discs.
• Remove all spanners and repair tools. Make a habit of checking to make sure that
the tile saw is free of all spanners and tools before turning the power on.
• Avoid accidental starts. Do not walk around with your finger on the trigger of
a power tool if it is plugged in. Make sure that the on/off switch is set to OFF
before plugging in any power tool.
• Use the correct extension leads. If you use extension leads outdoors, only use
those designed for outdoor use. Only use extension leads with thick enough
diameter core wires and roll out the whole lead.
• Use common sense and be careful. Think before carrying out any task, so that it
is carried out safely. Never operate machines/power tools when you are tired or
under the influence of medicine.
• Check the following before turning the tool on:
- That all guards and other parts are whole and in working order.
- That moving parts are free and correctly aligned.
- That no moving parts can get caught.
- That there are no visible defects.
- Other factors that can influence work execution.
3