Output Connectors - Sony UP-2800P Gebrauchsanweisung

Location and Function of Parts and Controls (continued)
5 NTSC/PAL (NTSC/PAL TV ) selector
(only for UP-2900MD/2950MD) (65, 66)
Set this selector according to the TV system of
the input signal. If you change this setting,
turn the printer power off, then back on again.
Selector position
NTSC
PAL
6 ~ AC IN connector
Used to connect the printer to a wall outlet
with the supplied power cord.
7 Equipotential ground terminal
connector 1
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environment" on page 2.

8 OUTPUT connectors (66)

Used to connect the video monitor.
Connector Connectable equipment
S-VIDEO Video equipment with Y/C separated input
connector.
VIDEO Video equipment with composite video
signal input connector
RGB SYNC Video equipment with RGB/SYNC input
connectors.
a) Models other than the UP-2300P are equipped with the
RGB/SYNC connectors.
Refer to "Important safeguards/notices for use
in the medical environment" on page 2.
9 STROBE (X-terminal) (only for UP-
2300P)
Used to connect to an electronic flash which
lights at instance the image is captured in the
memory.
112
Others
When setting
The NTSC system video equipment
is connected.
The PAL system video equipment is
connected.
a)