Attaching The Scrap Receptacle; Attaching The Output Tray; Attaching The Output Cover - Sony SnapLab UP-CR20L Handbuch

4
Gently unravel the ribbon without loosening it, and
place it in the ribbon tray.
Place the white spool in the front holder and the black
spool in the rear holder as shown.
5
Hold the center of the ribbon tray, and load it into the
unit.
6
Close the ribbon door.

Attaching the Scrap Receptacle

When printing, a margin of empty space is left between
each printout. These excess portions are cut off and
dropped into the scrap receptacle. Remove scraps from the
receptacle as soon as possible.
28
Loding the Paper Roll and Ink Ribbon

Attaching the Output Tray

When printing, printouts are ejected from the printer and
collect in the output tray.
1
Attach the output tray to the printer.
Attaching the output tray adapter
The output tray adapter prevents printouts from sticking
out of the output tray.
Use the adapter when printouts curl as shown.
Adjusting the output stopper position
Adjust the position of the output stopper according to the
printing pack in use. The positions for each printing pack
are indicated on the output tray, so attach the output
stopper accordingly. There are three positions to which to
adjust.

Attaching the Output Cover

Attach the output cover to the output tray. Doing so
prevents minor cuts and injuries that may result from