Sony UP-2800P Gebrauchsanweisung Seite 84

Setting Up the Printer (continued)
84
Installation and Adjustment
When a black line appears on the printout
Adjust the printout area according to the position of the line on the printout, by
using the H START and V START items on the menu.
Position where Menu adjustment
the black line appears item
On the right H START
(horizontal direction)
On the left
At the top V START
(vertical direction)
At the bottom
When the black line is at the right or left edge
W I NDOW S E T UP CO L OR n n n
L A Y SE T U P P R E S S
00 D OT S
H S T A R T (
V S T A R T 00 D OT ( S
H W I DT H 800 D OT S
V W I DT H 472 D OT S
Q 1 A 1 2 H F
When the black line is at the top or bottom
To clear the adjusted value
Press the MENU button from the WINDOW SETUP menu. The adjusted
values are cleared and the values are reset to the original ones.
Note
When a black line still appears, even after adjusting H START or V START,
change the printout size.
5
Select LAY SETUP by pressing the ◊ or √ button, then press the ∫ button.
The adjusted values are stored. The LAYOUT SETUP menu appears.
6
Press the MENU button.
The regular screen appears.
To check the adjustment result
Cature a new image and print it to check that no black frame appears on the
printout, that the image is not partially cut, and that no black line appears.
Button to be
used
∫ button
ı button
∫ button
ı button
H ST AR T
)
)
V ST AR T
S
Adjustment result
The image position shifts to the right
with the size remaining as is.
The image position shifts to the left
with the sized remaining as is.
The image position shifts up with the
size remaining as is.
The image position shifts down with
the size remaining as is.
:
0 0 DOT S
( )
:
0 0 DOT S
( )