Attaching The Scrap Receptacle; Attaching The Output Tray - Sony UP-DR250 Handbuch

2
Remove the ribbon tray.
3
Detach the white spool of the ink ribbon from the black
spool.
4
Gently unravel the ribbon without loosening it, and
place it in the ribbon tray.
Place the white spool in the front holder and the black
spool in the rear holder as shown.
5
Hold the center of the ribbon tray, and load it into the
unit.
6
Close the ribbon door.

Attaching the Scrap Receptacle

When printing, a margin of empty space is left between
each printout. These excess portions are cut off and
dropped into the scrap receptacle. Remove scraps from the
receptacle as soon as possible.

Attaching the Output Tray

When printing, printouts are ejected from the printer and
collect in the output tray.
1
Attach the output tray to the printer.
Loading the Paper Roll and Ink Ribbon
21