Timex W-177 Benutzerhandbuch Seite 14

Figure 3.1 – Timing Laps/Splits with the 30-Lap Model
CHRONO Mode Display
Format Example – The
current lap time (top) and
heart rate (bottom) are
displayed. The stopwatch
flag appears during
timing; the solid beating
heart flag indicates an
active HRM.
START/SPLIT Button –
In CHRONO Mode,
press to start the
Chronograph.
24
STOP/RESET/SET Button –
In CHRONO Mode, press to
stop or reset the
Chronograph.
HEART RATE Button –
Turn on or turn off the
heart rate monitor; also
used to change HRM
data position when heart
rate monitor is on.
It then returns to the running CHRONO Mode, which is still timing the current
lap/split. The watch stores data for the last 30 laps.
4. Press STOP/RESET/SET to stop timing.
5. Press START/SPLIT to resume timing, or press and hold
STOP/RESET/SET to reset the chronograph to zero. (Do not reset if you
wish to save the data for later review.)
TIMER Mode (30-Lap Model only)
This mode allows you to set a time from which the watch counts down to
zero. This feature is useful for fixed time events up to 100 hours. At the
end of the countdown, the Timer can be set to stop, repeat the countdown,
or switch to CHRONO Mode and start the chronograph.
While the Timer is running, you can press MODE to switch to any other
mode, such as TIME OF DAY, without disrupting its operation. An hourglass
flag appears when the Timer is active.
Setting the Timer
1. Press MODE until TIMER appears.
2. Press STOP/RESET/SET to enter TIMER Mode set state. The hours value
will be flashing.
3. Press START/SPLIT (+) or HEART RATE (-) to change values. Hold the
keys down to advance more quickly. When each value is set, press
MODE (NEXT) to move to the next values (MINUTES then SECONDS).
25