Flotec EVO-MULTIMAX 340 KIT Betriebsanleitung Seite 15

fectiveness must be checked before restarting,
taking into account the current regulations and
stipulations.
Unauthorised modifications,
manufacture of spare parts
The equipment may only be modified or altered
in agreement with the manufacturer. The use of
original spare parts and accessories approved
by the manufacturer is important for safety rea-
sons. The use of other parts can result in liabil-
ity for consequential damage being rescinded.
Unauthorised operating meth-
ods
The operational safety of the supplied equip-
ment is only guaranteed if the equipment is
used for its intended purpose. The limiting val-
ues given in the "Technical Data" section may
not be exceeded under any circumstances.
Instructions regarding acci-
dent prevention
Never work alone. Always wear a hard hat, safe-
ty glasses and safety shoes and, if necessary, a
suitable safety belt.
Before carrying out welding works or using
electrical devices, check to ensure there is no
danger of explosion.
For the sake of your health, be sure to pay me-
ticulous attention to cleanliness wherever you
are working.
Make sure that there are no toxic gases in the
working area.
Observe the relevant occupational health and
safety regulations and keep first aid materials
available.
In some cases, the pump and the pumping me-
dium may be hot and could cause burns.
For installations in areas subject to explosion
hazards, special regulations apply!
This appliance can be used by children aged 8
years or over and by persons with limited phys-
ical, sensory or intellectual capabilities, or with
limited experience and knowledge, provided
that they are supervised or have been instructed
in the safe use of the appliance and are aware
of the dangers involved. Children must not be
allowed to play with the appliance. Cleaning
and user maintenance must not be carried out
by children unless they are supervised.
The pump must only be connected to
sockets that have been installed
properly in accordance with the regu-
lations and are protected with a
FI-safety switch (RCD,30mA)
Only qualified electricians may carry
out electrical works to the pump or
the controls.
Always pull out the mains plug before
carrying out any work on the pump.
Check the rubber hose for mechanical
or chemical damage. A damaged or
kinked hose must be replaced.
ENGLISH
15 15