Memory Effect - ROBBE POWER PEAK 3 Sport Bedienungsanleitung

Additional screen displays
NO BATTERY
READY
General information about charging and discharging batteries
As a basic rule please be sure to observe the battery manufacturer's recommendations,
especially the information regarding maximum charge currents.
To ensure that the automatic Delta Peak circuit is able to work as efficiently as possible,
only properly balanced packs should be fast-charged. This means that new packs, and
packs which have not been used for a long time, should be discharged at regular intervals
and re-balanced by slow-charging at a low rate, typically C/10. To do this connect the bat-
tery but do not press any of the buttons.
An occasional complete discharge process also helps to avoid and/or eliminate the

MEMORY EFFECT.

It is certainly possible to charge a transmitter battery which is installed in the RC system
transmitter, but the charger's discharge functions are only available if you either by-pass the
protective diode in the transmitter's charge circuit, or remove the battery from the transmit-
ter and connect it to the charger using a direct charge lead.
Conversion work on the transmitter should only be carried out by an expert, ideally by your
nearest robbe Service Centre.
Recommended direct charge lead
No. 8262 F-series transmitter
Notes
- It is essential to set the correct battery type on the charger.
- The maximum charge and discharge currents vary according to the number of cells in
the pack. See "Specification" for details.
- Don't end the charge or discharge process simply by disconnecting the battery pack;
always stop the process by pressing the MODE button.
Mains PSU
If you use the Power Peak 7A mains PSU, Order No. 8415, the charger can also be ope-
rated from the 230 Volts mains supply, turning it into a universal 230 V AC and 12 V DC
charger. Note that the maximum currents
are restricted in this mode of operation
when used with high cell counts.
robbe Modellsport GmbH & Co. KG
We reserve the right to alter technical
specifications.
Operating instructions
POWER PEAK 3 Sport
No battery connected
Ready for use
No. 8263
12
Order No.
8425
International series