E) Adjusting The Ailerons (Only Item No. 233770); F) Mounting The Elevator Unit - Reely SKY Cessna 182 Bedienungsanleitung

e) Adjusting the Ailerons (only item no. 233770)

• First take up operation of the transmitter and
connect the flight battery.
• When the trim slider for the aileron (see figure
2, pos. 5) is in the centre position, the ends of
the ailerons (1) also have to be flush with the
rear edge of the wings (2).
• If one of the ailerons is too high or too low,
unhinge the clevis (3) on the aileron and turn
the clevis to adjust the length of the linkage
rod.
• Afterwards, re-insert the clevis and check the
position of the aileron.
• Repeat this adjustment process until the ailerons are in the ideal position in relation to the wing.
• The servo levers (4) are ideally adjusted ex works and should protrude vertically down from the
wing.

f) Mounting the Elevator Unit

• First push the elevator unit (1) into the fuselage
from the back without using an adhesive.
• Carefully push apart the top and bottom end
of the fuselage, so that the unit can easily be
inserted.
The rudder horn (2) of the elevator unit has to
point downwards.
Figure 10
Figure 11a
59