Getting Started With The Transmitter; A) Screwing The Antenna Of The Transmitter; B) Inserting The Batteries/Rechargeable Batteries - Reely SKY Cessna 182 Bedienungsanleitung



9. Getting Started with the Transmitter

Please note:
In the operating instructions, the numbers in the text always refer to the figure opposite
or the figures within the section. Cross references to other figures are indicated with the
respective figure number.
a) Screwing on the Antenna of the Transmitter
If necessary, the antenna of the transmitter is inserted as far as possible from the front/top through
the circular opening into the casing of the transmitter (see also figure 02, pos. 2) and is then turned
like a screw. Turn the antenna as much as manually possible. Use neither force nor tools to tighten it.

b) Inserting the Batteries/Rechargeable Batteries

For the power supply of the transmitter you will need eight mignon alkaline batteries (e.g. Conrad
Item No. 650117) or rechargeable batteries (AA). For ecological and also economical reasons it is rec-
ommended to use rechargeable batteries, since they can be recharged in the transmitter via a built-in
charging socket. To insert the batteries or rechargeable batteries, proceed as follows:
• The battery compartment lid (1) is located on
the rear side of the transmitter. Please press
the corrugated triangle and push off the lid
downward.
• Now insert the eight batteries or rechargeable
batteries in the battery compartment. Observe
the correct polarity of the individual cells. A
corresponding note (3) is located on the
bottom of the battery compartment.
• Afterwards, slide the lid of the battery
compartment back on from the bottom and let
the locking mechanism click into place.
Either a teacher/student cable with a 3.5 mm jack connector or an interface cable for a
flight simulator can be connected to the student socket (see figure 3, pos. 5).
Figure 3
51