Scope Of Delivery And Optional Accessories - Benning IT 105 Bedienungsanleitung

Measurements of the protective conductor resistance and of the insulating resistance must
be carried out at idle system parts only.

Do not touch the measuring probes!
During insulating resistance measurements, high electric currents might be applied to the
measuring probes.

Do not touch any metal parts of the test object during measurement.

Disconnect the BENNING IT 105 from the electrical system directly after the test is finished.

Only use the measuring leads included in the scope of delivery of the BENNING IT 105.
Use the BENNING IT 105 only in compliance with the intended use specified in this docu-

mentation. Non-observance might impair the protective function of the BENNING IT 105.
Before starting the installation tester, always check it as well as all measuring leads and

wires for signs of damage.
Should it appear that safe operation of the installation tester is no longer possible, it should be shut down
immediately and secured to prevent that it is switched on accidentally.
It must be assumed that safe operation is no longer possible
- if the instrument or the measuring leads show visible signs of damage, or
- if the installation tester no longer works, or
- after long periods of storage under unfavourable conditions, or
- after being subject to rough transportation, or
- if the device is exposed to moisture.
Maintenance:
Do not open the tester, because it contains no components which can be repaired by the

user. Repair and service must be carried out by qualified personnel only! (Exception: see
section 9.4 "Fuse replacement")
Cleaning:

Regularly wipe the housing by means of a dry cloth and cleaning agent. Do not use any
polishing agents or solvents!

3. Scope of delivery and optional accessories

The scope of delivery for the BENNING IT 105 comprises:
3.1 one installation tester BENNING IT 105
3.2 one transport case with accessory compartment (10198412)
3.3 one probe tip with TEST key (10162173)
3.4 one test cable with shock-proof plug (10198407)
3.5 one set of measuring leads/ alligator clips, red/ black/ green (10198406)
3.6 one carrying strap (10198409)
3.7 six mignon batteries 1.5 V (IEC LR6/ type AA) and one fuse (fitted in unit as initial equipment)
3.8 one operating manual
3.9 one calibration certificate
Parts subject to wear:
- The BENNING IT 105 contains a fuse as protection against overload:
One fuse, nominal current rating 1.6 A, 1000 V, superfast-acting (FF), breaking capacity ≥ 30 kA, D = 6.3
mm, L = 32 mm (part no. 10194027).
- The BENNING IT 105 is powered by six mignon batteries 1.5 V (IEC LR6/ type AA).
06/ 2018
BENNING IT 105

17