Scope Of Delivery - Benning PV 2 Bedienungsanleitung

Via the 4 mm safety test leads, voltage measurements on mains supply circuits
are possible. Via the 4 mm test sockets
used only in electric circuits of overvoltage category III with max. 300 V AC/ DC
for phase-to-earth measurements. For voltage measurements via the 4 mm test
sockets and
sockets and
WARNING! Be careful when working with bare conductors or main line carrier!
Contact with live conductors will cause an electric shock!
Remember that work on electrical components of all kinds is dangerous. Even
low voltages of 30 V AC and 60 V DC may be dangerous to human life.
Before starting the appliance tester up, always check it for signs of damage.
Do not use a damaged BENNING PV 2! Damaged measuring leads must be
replaced!
Only use safety measuring leads, which are supplied with the BENNING PV 2.
Use the BENNING PV 2 only in compliance with the intended use specified in
this documentation. If the BENNING PV 2 is used in a manner not specified by
this document then the protection provided by the equipment may be impaired.
If the BENNING PV 2 is being used to determine the presence or absence
of hazardous voltages, always prove the operation of voltage measurement
function before and after use by means of a known voltage source or proving
unit.
Use the BENNING PV 2 under dry ambient conditions only.
- the device is exposed to moisture.
In order to prevent danger
- do not touch the bare measuring probe tips of the measuring leads,
- plug the leads into the correspondingly marked jacks at the measuring
instrument
Maintenance:
Do not open the tester, because it contains no components which can be
repaired by the user. Repair and service must be carried out by qualified
personnel only!
Cleaning:
Regularly wipe the housing by means of a dry cloth and cleaning agent. Do not
use any polishing agents or solvents!
3.

Scope of delivery

12/ 2017
, please disconnect the PV measuring leads from the PV test
before measuring.
and , the BENNING PV 2 must be
18