Troubleshooting
With this car radio, you have purchased a product built to the state of the art and operationally safe.
Nevertheless, problems or errors may occur.
Therefore, we would like to describe how to eliminate possible errors here:
Always observe the safety information!
No playback, no display, and the lights are out:
•
The vehicle fuse is defective. Look up the respective fuse in the operation manual of your car. Check the fuse.
•
The fuse of the CD tuner is defective. Remove the CD tuner and check the fuse.
•
The positive line/earth line is loose. Remove the CD tuner and check the connections of the cables.
Playback only through one speaker:
•
The balance control is wrongly adjusted. Adjust the balance control as described.
•
The speaker connection has come loose. Remove the CD tuner and/or speakers and check the connections.
Playback only through the front or rear speakers:
•
The fader control is not adjusted correctly. Adjust the fader control.
•
The speaker connection has come loose. Remove the CD tuner and/or speakers and check the connections.
In radio operation hardly any stations can be received:
•
The aerial is not pulled out completely. Pull out the aerial to its full length.
•
The aerial connection has come loose. Remove the CD tuner and check the connection.
•
The aerial is defective. Check the connection, earthing and the aerial itself.
Interferences during radio and CD playback:
•
Interferences reach the CD tuner via the positive line. Install an additional interference suppression coil into the
positive line. If necessary, also equip the vehicle with spark-plug suppressor sockets, distributor arms etc. to
suppress interferences.
Interference noise during CD playback:
•
The installation angle of max. 30° was exceeded.
•
The CD surface is scratched or contaminated.
82
Operating Instructions
English