Removal - Renkforce AN-8015BT Bedienungsanleitung

• Protect your CD tuner from vibrations with the bolt at the back of the unit. In most vehicles, such a safety fastening
is provided for. If this is not the case in your car, fasten the CD tuner with the enclosed punched metal strip. For
the fastening, proceed as shown in the following figure:
• When you have made all the electrical contacts (see "Electric Connection") insert the CD tuner into the frame until
it locks in.
• Push the frame cover of the front operating unit onto the device again.

Keep the two unlocking keys. You will need them for a later removal of the CD tuner.

Removal

• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system by bending it slightly to the outside and pulling it off
from the unit.
• Insert the two unlocking keys into the lateral slots between the CD tuner and the installation frame, until the CD
tuner unlocks.
• Remove the fastening screw at the back of the unit.
• Carefully pull out the radio with the unlocking keys from the installation frame.
• Remove all connection plugs from the device.
54
Operating Instructions

English