Troubleshooting; Risk Of Electric Shock; Error Correction - Parkside PMNF 1350 C3 Originalbetriebsanleitung

GB IE NI
Electrical machines do not belong
with domestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts em-
ployed can be separated out and thus
recycled use can be implemented. Ask
our Service-Center for details.
• Defective units returned to us will be dis-
posed of for free.

Troubleshooting

Always unplug the shredder before working on it.

Risk of electric shock!

Problems
Device doesn't
start
Grinding tool
does not move alt-
hough the engine
is runningt
Engine is slower
and stops
Grinding disc
does not rotate
smoothly, abnor-
mal noises can be
heard
1 6
Possible Cause
Mains voltage missing
Main circuit breaker is trip-
ped
On/off switch (
be defective
Engine faulty
Threaded clamping flange
(17) is loose
Workpiece, remaining work-
pieces block drive
Device is overloaded
through workpiece
Threaded clamping flange
(17) is loose
Cutting discs are defective

Error correction

Check the socket, mains cable, line,
mains plug, repairs to be carried
out by qualified electrician if neces-
sary, check main circuit breaker.
2) may
Repair by Customer Care
Tighten threaded clamping flange
(17) (see „Changing disc")
Remove blockages
Reduce pressure on cutting tool
Workpiece unsuitable
Tighten threaded clamping flange
(17) (see „Changing disc")
Change cutting discs