D) Reception Test For The "Meteotime" Signal; E) Selecting The Country/City For The Weather Display - Conrad DV322 Bedienungsanleitung

d) Reception test for the "METEOTIME" signal

Because some weather information is contained in each DCF signal per second (the so-called
"METEOTIME" signal), it is very easy to perform a function test contrary to standard DCF
clocks.
Briefly press the "TEST" button on the rear of the weather station.
"SCAN" (reception test) is displayed on the bottom, and the "METEOTIME" reception symbol
to the left of the temperature/air humidity display (see arrow in the illustration below) starts to
blink.
= perfect reception
= no reception
If necessary, change the installation site until "
The reception test is terminated automatically after one minute (or press the button "TEST"
again before). Of course, you can restart the reception test again. Proceed as described
above.

e) Selecting the country/city for the weather display

You can select up to 5 cities whose weather forecast can be displayed later with the buttons
"" and "".

Chapter 21 includes a list of all available cities.
Proceed as follows for selecting:
• Keep the button "SET" depressed (approx. 3 seconds) until "COUNTRY" appears on the
bottom of the display.
• With the buttons "" and "" select the country (e.g. "D/GER" for Germany) and confirm
your selection by briefly pressing the button "SET".
Now the display shows "CITY".
• Select a city with the buttons "" and "".
Confirm the setting by briefly pressing the button "TEST" on the back of the weather station.
A small tick appears above the name of the city.
66
" is displayed.