C) Inspecting The Control Functions; Range Test - Reely Flame Bedienungsanleitung

c) Inspecting the Control Functions

After switching on the transmitter and connecting the driving battery to the model's speed controller, your
model is ready for operation. The motor should not start up or hum in this moment.
Check the rudder linkage.
Operate the steering wheel for steering (figure 6,
item 1). Steering to the left must cause the rudder
(viewed from behind in driving direction) to swivel to
the left as well.
If this is not the case, you need to activate the
steering servo reverse function at the transmitter
(see operating instructions of the remote control).
If the steering wheel for the steering function at the
transmitter, as well as the trimming for it are in the
neutral position, the rudder must be placed centrally.
Otherwise, the trimming at the transmitter must be
adjusted accordingly (see operating instructions of
the remote control system).
Alternatively, or if transmitter trimming is no longer sufficient, you need to readjust the linkage with the control wheel in
the neutral position and neutral trimming by loosening the screws at the steering linkage (figure 3).
„Metal/metal" screw connections must be secured against unintended loosening either with so-called stop
nuts or with a drop of threadlocker varnish.
Check the function „driving forwards". The throttle lever of the transmitter (figure 6, item 2) permits smooth adjustment
of the model's driving speed. The farther you push the lever to the handle, the faster must the ship's propeller turn and
the faster will the ship move forward.
If the motors only start up when the throttle lever is pushed forwards, you need to activate the reverse function at the
transmitter for the control function „driving forwards". For this, observe the operating instructions for the remote control
system.
d) Range Test
Before first use, the drive battery and any rechargeable batteries used in the transmitter have to be charged as
instructed by the manufacturer.
Perform a range test of the remote control system first. Switch on the remote control and then the receiver. Check the
range of your remote control with a helper by having the helper hold the operational model ship and you moving away
from the model. Control must work interference-free at least at a distance of 50 metres.
34
Figure 6