Herunterladen Inhalt Inhalt Diese Seite drucken

E) Setting The Trimming Flaps; F) Boat Rack Installation - Reely Flame Bedienungsanleitung

Elektro-schiffsmodell arr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

For this, observe the notes in the following chapter „Model Commissioning".
Finally, the hose for water cooling (4) must be pushed on.
Check the linkage for tight fit and damage before any voyage. A damaged or loose linkage/attachment (e.g.
loose screws, see figure 3, item 2 and 3) must be repaired before the voyage. If this is not observed, the
linage rods and/or rudder system may come loose unintended in operation. There is a danger of further
damage to your model (e.g. the steering servo blocks). The model will also no longer be controllable.
Also observe the following information in the chapter 9 „Model Commissioning".
„Metal/metal" screw connections must be secured against unintended loosening either with so-called stop
nuts or with a drop of threadlocker varnish.

e) Setting the Trimming Flaps

Your model has two trimming flaps at the left and right of the tail (figure 3, item 6). These trimming flaps serve to
optimise sliding of the model. Twisting of the set screws slightly adjusts the trimming flaps. After adjustment of the
screws, they must be countered with the nuts and thus protected from independent loosening.
The model sliding properties depend on many factors. For example, the weight and installation site of the
drive battery and/or the properties of the water surface (many or few waves) influence the model sliding
properties. Therefore, these operating instructions cannot offer specific setting information. You need to
perform operation tests to find the best settings.

f) Boat Rack Installation

The scope of delivery includes a boat rack of wood
that has to be assembled and glued together first.
Build the boat rack of the four wood parts as shown
in figure 4.
The side parts (figure 4, item 1) must be built so that
the wide side points down.
The side parts are attached into the long parts (figure
4, item 2).
Glue the wood parts on with a drop of viscous in-
stant adhesive or some 5-minute epoxy glue.
32
Figure 4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis