Before Commissioning; During Operation - Reely Flame Bedienungsanleitung

b) Before Commissioning
• Make sure that no other models are operated on the same channel (transmitter frequency) within the range of the
remote control (for remote control systems at 27/40 MHz). Otherwise, you will lose control of the remote-controlled
models!
For 2.4 GHz remote control systems, always check that concurrent operation of two or more remote control systems
in direct proximity is possible without interferences.
• Regularly check the functional reliability of your model and the remote control system. Watch out for any visible
damage such as defective plug connections or damaged cables. All moving parts of the model must run smoothly
but should not have any play in their bearings.
• Charge the drive battery, which is necessary for operation, as well as the rechargeable battery that may be inserted
in the remote control according the manufacturer's instructions.
• If batteries are used as a transmitter power supply, make sure that they have sufficient remaining capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• Before operation, always control the trim controller settings of the on the transmitter for the various steering directions
and, if necessary, adjust them.
• Always align the transmitter aerial so that the aerial tip points upwards as vertically as possible in the transmitter
position favoured by you to operate your model. Otherwise, the transmitter may not send its control signals as well
as possible, which may cause considerable reduction of the range.
• Before any commissioning, check for correct and tight fit of the ship's propeller and for any damage to them.
• Always switch on the transmitter first. Then the drive battery of the model may be connected to the speed controller.
Otherwise, unexpected reactions of the receiver system may occur and the drive with the ship propeller might start
up unintentionally! Danger of accident and injury!
• When the ship propeller is running, make sure that neither objects nor body parts are in their rotating and suction
area.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Improper operation may cause serious injury and property damage! Therefore, make sure that there is a sufficient
safety distance to any persons, animals or objects in operation.
• Select suitable body of water to operate your model. In doubt, ask the person responsible for the body of water
whether operation of your model is permitted there.
• The selected body of water must be free of climbers (e.g. seaweed) for operation of your model. There also must be
no objects (e.g. branches) floating in the water.
• Observe currents and other detriment conditions in the selected body of water that may make operation of the model
difficult or even impossible. There is a danger of the model being lost!
• Drive your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• Never drive right towards any swimming persons or animals.
27