B) Inspecting The Control Functions; Range Test - Reely SEA Aqua Passion Bedienungsanleitung

b) Inspecting the Control Functions

After switching on the transmitter and the receiver, your model is ready for operation. Only the motor needs
to be started.
Attention!
The ship propeller is very sharp-edged and may cause injury and/or property damage when handling, replacing
and in operation.
Check the rudder linkage.
Operate the steering wheel for steering (figure 4,
item 1). Steering to the left must cause the rudder
(viewed from behind in driving direction) to swivel to
the left as well.
If this is not the case, you need to select the steering
servo reverse function at the transmitter (see opera-
ting instructions of the remote control system).
If the steering wheel for the steering function at the
transmitter as well as the trimming for it are in the
neutral position, the rudder must be placed centrally.
Otherwise, the trimming at the transmitter must be
adjusted accordingly (see operating instructions of
the remote control system).
Alternatively, or if transmitter trimming is no longer sufficient, you need to readjust the linkage with the control wheel in
the neutral position and neutral trimming by loosening the screws at the steering linkage (figure 2).
„Metal/metal" screw connections must be secured against unintended loosening either with so-called stop
nuts or with a drop of thread locker varnish.
Check the throttle function. The throttle lever of the transmitter (2) permits smooth adjustment of the model's driving
speed. The farther you push the lever to the handle, the faster must the ship's propeller turn and the faster will the ship
move forward.
Attention!
The model has no centrifugal force clutch. This causes the ship's propeller to rotate as soon as the motor is
running.
Therefore adjust the linkage of the throttle servos so that you can deactivate the motor trimming (motor off).
The trimming must be set to increased idle throttle again for operation of the model, so that the motor will
continue to run securely after placement in the water. Also observe the setting notes on the motor in
chapter 11.
c) Range Test
Before first use, the receiver battery and any rechargeable batteries used in the transmitter have to be charged
according to the manufacturer's instructions.
Perform a range test of the remote control system first. Switch on the remote control and then the receiver. Now check
the range of your remote control with a helper, by having the helper hold the operational model ship and you moving
away from the model. Control must work interference-free at least at a distance of 50 metres.
Figure 4
33