Cappuccino Maker User Instructions (Where Contemplated) - Faema E91 Ambassador A2 Handbuch

English

7. Cappuccino maker user instructions (where contemplated)

Insert the tube (18d) into the milk.
Place a container under the cappuccino maker (18).
Remove the knob (18b) to facilitate the circulation of air.
Completely rotate the air adjustment screw (18a) clockwise,
then turn it back by half a turn.
Completely rotate the temperature adjustment screw (18c)
clockwise, then turn it back by half a turn.
At this point, press the key (16) to obtain milk.
Adjustment of the cappuccino froth
Too much froth:
Finely rotate the air adjustment screw (18a) clockwise.
Too little froth:
Finely rotate the air adjustment screw (18a) anticlockwise.
Cappuccino temperature
If the cappuccino is too hot:
Finely rotate the temperature adjustment screw (18c)
anticlockwise.
If the cappuccino is not hot enough:
Finely rotate the temperature adjustment screw (18c)
clockwise.
Distribution of hot unwhipped milk
Press and completely push in the knob (18b), then press the
milk distribution key (16).
8. How to access the programming function
To enter the programming mode, press STOP/progr button
(30) and keep it pressed for a few seconds; the buzzer sounds
intermittently.
To exit the programming mode, after programming the
various drinks coffee and water, press STOP/progr button
(30) again.
18a
18b
47
18
18d 18c
30
English
30