Troubleshooting - Conrad 67 21 58 Bedienungsanleitung

11. Troubleshooting

Status
The rear cover cannot be
removed inspite of un-
screwed retaining screw.
Although 'PROJECTION'
is on the setting 'ON', the
time is not projected.
LED-Lamp cannot be
switched on.
The automatically set
time is an hour ahead/be-
hind the actual local time.
Continuous reception of
the DCF-Radio signal is
not possible.
Sound of nature cannot
be turned on separated
from dim light
After power failure, the
product settings
changed.
28
Possible cause
The cover snaps into housing
and hence also clamps without
retaining-screw.
The projection of the time can
be activated only with connect-
ed mains supply unit.
LED-Lamp can be switched on
only by connected mains sup-
ply unit.
Sent DCF-Radio signal from
Germany does not correspond
to the local time zone.
Local reception conditions pre-
vent the reception of the DCF-
Radio signal.
No malfunction. Sound of na-
ture and dim light can be acti-
vated/deactivated together.
Saving of the current settings
are after power failure is possibly
only with inserted batteries.
Remedy
By slight shifting loosen
and remove the cover.
Power is supplied through
power plug unit.
Power is supplied through
power plug unit.
Adjust time according to
instructions.
Select other set-up loca-
tion to receive DCF-Radio
signal.
Setting the time manually.
-
Inserting new batteries.