E) Elevator Function (Mode 2) - Reely Bimot Bedienungsanleitung

e) Elevator Function (Mode 2)

If the control stick for the elevator function (see figure 1, item 4) is moved down, the elevator must deflect to the top.
The rear rudder edge must be deflected upwards by approx. 4 - 5 mm. In flight, the landing gear is pressed downwards
and the model ascends.
If the control stick for the elevator function (see figure 1, item 4) is moved up, the elevator must deflect to the top. The
rear rudder edge must be deflected downwards by approx. 4 - 5 mm. In flight, the landing gear is pressed upwards
and the model dives.
This control function is required to put the model into a normal light position if it wants to ascend too much due to a
control error or a gust of wind.
Figure 17
Figure 18
51