S) Mounting The Propeller; Mounting The Receiver - Reely EXTRA 300 Bedienungsanleitung

s) Mounting the Propeller

First place on one of the washer discs, then the spinner plate (1) and then the
propeller (2) and finally the second washer onto the propeller catch.
Then screw on the propeller nut (3) and tighten using an 8 mm spanner.
Note:
Make sure the spinner plate and the propeller are correctly
positioned.
Then put the spinner cap in place (4) and tighten both of the attachment
screws.
Turn the propeller several times by hand in order to check the correct rotation
of the propeller and the spinner.
t) Mounting the Receiver
Once you have checked the function of the connected servos and the flight
controller, the receiver (1) is fitted in the cockpit with double-sided adhesive
or servo tape in accordance with the illustration.
The two rear cables (2) are the extension cables for the elevator and vertical
rudder servos.
The aileron servo (3) cable is fed in through the front fuselage opening and
can be directly attached without an extension cable depending on the type
and installation of the receiver.
The front cable (4) is the extended connection cable from the flight controller.
The antenna wire (5) is guided to the rear to an opening in the fuselage floor.
We recommend attaching the antenna to the fuselage wire in a piece of
Bowden cable tube.
50
Figure 25
Figure 26