Safety Instructions - Renkforce 1282378 Bedienungsanleitung

6. Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you
do not follow the safety instructions and information on proper handling in this manual, we
assume no liability for any resulting personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing
material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
• Before connecting to the mains, make sure that your local AC mains voltage matches the
specifications on the nameplate.
• The device was constructed according to protection class I. Only a proper grounded mains
socket (110 - 240 V/AC, 50/60 Hz) connected to the public electricity grid should be used as
voltage source.
• Never pour any liquids over electrical devices or put objects filled with liquid next to the device.
If liquid or an object does enter the interior of the device, power down the respective socket
(e.g. switch off circuit breaker) and then pull the mains plug from the mains socket. Do not use
the product again and take it to a specialist workshop.
• Never use the product immediately after it has been brought from a cold room into a warm one.
The condensation generated could destroy the product. In addition, the plug-in power supply
unit could produce a fatal electric shock! Allow the product to reach room temperature before
connecting it to the power supply and putting it to use. This may take several hours.
• The mains outlet must be located near to the device and be easily accessible.
• Never pull the mains plug from the socket by pulling at the cable. Always pull it from the mains
socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device for an extended
period of time.
• For safety reasons, disconnect the mains plug from the mains socket during thunderstorms.
31