Troubleshooting - Renkforce 1282378 Bedienungsanleitung

DMX DMX value
channel
14
000 - 19
20 - 39
40 - 59
60 - 79
80 - 99
100 - 119
120 - 139
140 - 159
160 - 179
180 - 199
200 - 219
220 - 255

12. Troubleshooting

With this moving head, you have purchased a product that is built according to the latest technology and is
safe to operate. However, problems and malfunctions may still occur. For this reason, the following section
provides an explanation on how to rectify possible malfunctions.
The device does not work after being connected to the power supply:
• The mains plug is not plugged into the mains socket properly.
• The mains cable is not properly inserted into the mains connection on the device.
• The mains socket is not supplied with electricity.
There is no apparent response to DMX commands:
• The blackout mode is enabled on the DMX controller.
• The DMX address is not set correctly.
• The connection between the DMX controller and the moving head has been interrupted.
• The DMX cable is too long or is damaged. Use a special DMX high frequency cable. Try to lay the DMX
cable away from sources of interference.
• The polarity of the DMX connections on the DMX controller and the moving head is different.
• If possible, try using another DMX controller.
Function
Moving head control
No function
Rotating-swivel movement, blackout enabled (after 3 s)
Rotating-swivel movement, blackout disabled (after 3 s)
Auto1 (enabled after 3 s)
Auto2 (enabled after 3 s)
Sound1 (enabled after 3 s)
Sound2 (enabled after 3 s)
Custom
Test (enabled after 3 s)
No function
Reset (enabled after 3 s)
No function
47