Renkforce 1282378 Bedienungsanleitung Seite 40

• Use the UP / DOWN buttons to select the desired rotating direction and confirm your selection with the
ENTER button.
NORMAL = normal rotating direction
REVERSE = inverted rotating direction
• Press the MENU button until "INVERT" appears and then press the ENTER button to confirm. Select "TILT"
with the UP / DOWN buttons and confirm your selection with the ENTER button.
• Use the UP / DOWN buttons to select the desired swivel direction and confirm your selection with the
ENTER button.
NORMAL = normal swivel direction
REVERSE = inverted swivel direction
Limiting the rotating and swivel angles
To set the moving head to the working environment, the rotating and swivelling angles (P=PAN, T=TILT)
can be limited. The moving head moves in real-time as you make the settings so that you can follow your
settings and make any necessary adjustments.
All of the moving head's rotating and swivel movements are limited to the set values (positions) in the TEST,
AUTO and SOUND modes if "USE" was confirmed with "YES".
• Press the MENU button (4) until "RANGE" appears and then confirm with the ENTER button (3).
• Press UP (1) or DOWN (2) until "P/START" appears, press the ENTER button and then set the desired
starting position in the rotation plane (PAN) using the DOWN or UP buttons. Confirm with ENTER and
press MENU to go back one step in the menu.
• Select "P/FINISH" using the DOWN / UP buttons, press ENTER and then set the desired end position in the
rotation plane (PAN) using the DOWN or UP buttons.
• Press the MENU button until "RANGE" appears and then confirm with ENTER.
• Press UP or DOWN until T/START appears, press ENTER and then set the desired starting position in the
swivel plane (TILT) using the DOWN or UP buttons. Confirm with ENTER and press MENU to go back
one step in the menu.
• Select "T/FINISH" using the DOWN / UP buttons, press ENTER and then set the desired end position in the
swivel plane (TILT) using the DOWN or UP buttons.
• To activate the settings, select "USE" and then confirm "YES" using the ENTER button. To disable these
settings, select "NO" under "USE" and confirm with the ENTER button. The current option flashes during
the setting process.
Restart
It may be necessary to restart the moving head after making extensive changes to the configuration.
Follow the steps below to restart the moving head.
• Keep pressing the MENU button (4) until "INTRO" appears. Confirm the option with the ENTER button (3).
• Select "RESET" using the DOWN (2) and UP (1) buttons, press ENTER and then select "YES" or "NO" with
the DOWN or UP buttons.
• Confirm the restart with the ENTER button. The internal controller restarts the moving head.
"WELCOME BUSY ..." will appear on the display during start-up.
When restarting with an external DMX controller, the "DMX" option under "SPECIAL RESET" must
be selected.
40