C) Operating Modes Without A Dmx Controller - Renkforce 1282378 Bedienungsanleitung

Reset to factory settings
The device can be reset to the factory settings in the event of a fault or to reload the initial settings.
• Keep pressing the MENU button (4) until "DEFAULT" appears. Press the ENTER button (3) to confirm.
• Select "YES / NO" with the DOWN (2) / UP (1) buttons. Confirm your selection with the ENTER button.
Press the MENU button to exit the reset menu.
• If you selected "YES", the internal controller loads the factory settings and restarts the moving head.
"WELCOME BUSY ..." will appear on the display during start-up.
• "WELCOM ADDR: 001" will appear on the display after start-up is complete (DMX starting address = 001).
Carrying out a test run
You can carry out a test run of the preset settings, e.g. the rotating angle limit. The moving head will execute
rotating and swivel movements and colour effects according to the preset settings. This can help you to
check whether any settings exist and that they are executed correctly, e.g. limits on the rotating and swivel
angle.
• Press the MENU button (4) until "INTRO" appears and then confirm with the ENTER button (3).
• Press the DOWN (2) and UP (1) buttons until "RUN" appears and then confirm the selection with the
ENTER button.
• Press the DOWN / UP buttons until "TEST" appears and then confirm the selection with the ENTER
button. The moving head then begins the test run.
• End the test by selecting a passive mode from the RUN menu, as described above. You are recommended
to select the SLAVE mode. The moving head moves back to the starting position and the light effects are
turned off. If you select modes such as "SOUND1/2" and "CUSTOM", the moving head stays in the current
position and the light stays on.
Enabling the key lock
You can lock the keys to prevent unauthorised use of the moving head.
• Press the MENU button (4) until "INTRO" appears and then confirm with the ENTER button (3).
• Press the DOWN (2) and UP (1) buttons and then select "KEYLOCK". Confirm your selection with the
ENTER button.
• Press the DOWN / UP buttons to select "YES" and confirm with the ENTER button. The buttons on the
control panel are now locked. This means that it is no longer possible to operate/program the moving
head using the control panel buttons.
• To unlock the keys, enter the password by pressing the UP –> DOWN –> UP –> DOWN buttons in this
order and then confirm with ENTER. The key lock is now disabled.

c) Operating modes without a DMX controller

• Keep pressing the MENU button (4) until "INTRO" appears. Confirm with ENTER (3) .
• Use the UP (1) / DOWN (2) buttons to select "RUN" and confirm with the ENTER button. You can choose
from the following operating modes:
41