Conrad Profi Bedienungsanleitung Seite 47

Display of Single Values with their respective Time and Date
If during display of the minimum or maximum values one of the Arrow keys (←) or
(→) is pressed, nothing but the minumum or maximum value of the indoor
temperature with its respective assigned time and date will be diplayed.
Now by use of the Arrow keys and the Min/Max key each single minimum or
maximum value with its assigned time and date of storage can be selected.
Additionally with the maximum wind strength the wind direction at the time of storage
will be displayed.
Note!
During this display mode all other sections of the LCD will stay invisible.
Selective Reset of Stored Values
If during display of any selected minimum or maximum values the "Reset" key is
pressed for appr. 2 seconds, the respectively assigned minimum or maximum values
will be erased and reset.
Reset of all Stored Values
If during display of the minimum or maximum values the "Reset" key is pressed for
appr. 2 seconds, all stored values will be erased and reset.
Alarm Function
As soon as any measurement of the Weather Station exceeds or falls below a set
alarm value, the air pressure tendency display, air pressure history, weather icon
and wind direction display will generally be switched off. The display then only
shows the particular section of the LCD where the value has fallen outside of the
set alarm window. The symbol „AL" will also be displayed.
If this does apply to more than one display or measurement section, their display
will also be shown in case of alarm.
By use of the „Sensor" key the alarm settings of the Outdoor Sensors can be
scanned.
The alarm arriving first will including its assigned sensor identification be shown in
the display.
In case of alarm the Weather Station will stay in the „Alarm" display mode until the
„Alarm" key is pressed and the display has thus returned to the display of their
current values.
In case of alarm there will additionally be an acoustic signal, which is composed of
five single tones. The signal will be repeated every 30 minutes for a total time span
of max. 7.5 hours. The alarm will be terminated when the values of the respective
measurement section have returned to within their programmed value range as
well as after additionally pressing the „Alarm" key (Return to the display mode for
the current data).
47