Conrad Profi Bedienungsanleitung Seite 41

As with the Remote Outdoor Sensor the magnet for activation of the system must
be inserted into an opening provided for at the back of the unit. The magnet must
tightly be pressed into the opening and will stick out by appr. 4 mm.
The activation of the Remote Wind Sensor also takes place by inserting a small
magnet into the opening provided for. In this case the magnet holder is placed
above the holder tube mounting (opposite the solar cell).
In order to insert the magnet into the Remote Rain Volume Sensor the upper part
has first to be removed by pressing and turning the upper part in a clockwise direction
with regard to the lower part. In the center of the electronics casing there is a holder
for the bar magnet activating the electronics. Insert the color marked magnet
according to its correct polarity into the holder (also see Page 39).
After pressing the magnets into their holders the sensors will take up data
transmission.
The Remote Indoor Sensor needs two Mignon AA, IEC LR6, 1.5V batteries for
operation. To insert the batteries the battery compartment needs to be opened.
Insert the batteries observing the correct polarity in accordance to the engraved
polarity marking in the battery compartment. Replace the cover of the battery
compartment.
Approximately 12 minutes after activating the last sensor, insert four Mignon AA,
IEC LR6, 1.5V batteries into the Base Station observing the correct polarity.
Upon inserting the batteries into the Base Station a short initializing phase takes
place during which all segments of the LCD will shortly be displayed. Following this
segment test the Base Station will automatically switch into a so called test mode
during which each data reception is shown on the display and acknowledged by
the sound of a signal tone. For better distinction there generally is only the display
of the sensor received last while the data of all previously received sensors are
being erased. The perfect reception of all sensor data can thus be checked quickly
and easily.
Note!
Under critical reception conditions this test mode also helps to find the best
possible location for good reception. To do this the respective sensor simply
must also be set to its test mode in order to transmit a data telegram every 4
seconds.
In order to activate this test mode the batteries from the Remote Indoor Sen-
sor and the magnets from the Outdoor Sensors have to be removed and re-
inserted after a waiting period of at least 60 seconds.
After approximately 30 minutes the Base Station will automatically terminate this
test mode and switch over to its normal reception mode. By pressing any function
key the test mode can be terminated earlier at any time.
41