Arai RX-7RC Gebrauchsanleitung Seite 26

q
e
24
w
r
English
To replace the left chinstrap cover (D-ring side),
ensure the female chinstrap end snap side of the
chinstrap and the leatherette side of the chinstrap
cover both face outward, slip the chinstrap cover
onto the chinstrap.
Position the plastic chinstrap anchor cover over the
steel anchor and push the cover in the anchor until
the tab on the back of the cover snaps fully home.
To replace the right chinstrap cover (long side),
ensure the cap side of the chinstrap end snap (Arai
logo impressed) on the chinstrap and the leatherette
side of the chinstrap cover both face outward, slip
the chinstrap cover onto the chinstrap.
Position the plastic chinstrap anchor cover over the
steel anchor and push the cover in the anchor until
the tab on the back of the cover snaps fully home.
TO REMOVE/REPlACE NECKROll
RX-7GP / CORSAIR-V / QUANTUM / RX-Q
First remove the cheekpads as per previous
instructions.
To remove the neckroll, pull out the neckroll end
tabs, which are inserted into the chin center pad
at both sides. Grasp center of the neckroll firmly,
rotate it to either direction by 3cm – 4cm (1-1/4"
– 1-1/2") and remove it from the helmet.
To wash the neckroll, put it into lukewarm water
with small amount of laundry soap or your own
shampoo and wash gently by hand. Rinse well with
fresh water and wipe off with a soft cloth. Dry it in
the shade at ambient temperature.