Charging Battery - Kärcher MIC 34C Betriebsanleitung

10.5.5 Charging battery

Danger
Risk of injury! Comply with safety regulations on the han-
dling of batteries. Observe the directions provided by the
manufacturer of the charger.
Danger
Charge the battery only with an appropriate charger.
 Remove the battery.
 Clamp off the minus pole of the battery.
 Disconnect the positive terminal of the battery.
 Connect positive terminal cable from the charger to the
positive pole connection on the battery.
 Connect negative terminal cable from the charger to
the negative pole connection on the battery.
 Plug in mains connector and switch on charger.
 Charge battery using lowest possible level of charging
current.
NOTICE
When the battery is charged, first remove the charger from
the mains and then disconnect it from the battery.
10.5.6 Replacing wheel
Danger
When carrying out repairs on public highways, wear warn-
ing clothing when working close to passing traffic.
DANGER
Risk of injury!
Check stability of ground. Also secure the machine with
wheel chock(s) to prevent it rolling away.
 Park the machine on an even surface.
 Remove ignition key.
 Lock parking brake.
 Position vehicle jack at the appropriate mounting point
for the front or rear wheel.
NOTICE
Use a suitable commercially available vehicle jack.
Intake points for the jack
 Loosen the wheel nuts/wheel bolts by about 1 revolu-
tion using a suitable tool.
 Raise machine using vehicle jack.
 Unscrew the wheel nuts/wheel bolts and remove them.
 Remove wheel.
 Have the defective wheel repaired by a specialised re-
pair shop.
 Place the wheel and screw in the wheel nuts/wheel
bolts all the way; tighten them lightly.
 Lower machine using vehicle jack.
 Torque the wheel nuts/wheel bolts to the required
torque.
58
Tightening torque for front tyres
Tightening torque for rear tyres
10.5.7 Check engine oil level and top up, if
required
1 Oil cap (engine)
2 Oil filter
3 Oil dipstick
4 Oil drain screw
 Park the machine on an even surface.
 Pull out oil dipstick.
 Wipe off oil dipstick and insert.
 Pull out oil dipstick.
 Read the value of the oil level.
 Insert the oil dip again.
– The oil level must lie between "MIN" and "MAX" marking.
– Add motor oil if the oil level is below the "MIN" marking.
– Do not fill oil above the "MAX" marking.
 Remove oil cap.
 Fill in motor oil.
Oil grade: Refer to chapter "Technical data"
 Close oil cap.
 Wait at least 5 minutes.
 Check engine oil level.
CAUTION
An oil level that is too high leads to damages of the engine
by overheating. If the oil level exceeds the "MAX" mark, oil
must be drained until the correct oil fill level has been
reached.
24
-
EN
83 - 85 Nm
83 - 85 Nm