Battery Charging; Ending Operation; Transport; Storage - Kärcher GSH 2 Plus Bedienungsanleitung

To stop the device, release the ON/OFF button.
Note
If the device is mounted on the telescoping handle, the
ON/OFF button on the device has no function.
DANGER
Risk of injury when lifting the unit with the tele-
scopiing handle!
The device cannot be guided safely when lifting with the
telescoping handle, and may get out of control and
cause cuts or bruises.
Do not lift the device with the telescoping handle.
Only guide the device with the wheels on the ground.
7. Guide the device with the telescoping handle.
Illustration P
Illustration Q
Cutting bushes / hedges / shrubs with the
shrub shears
1. Mounting the shrub shears, see chapter Mounting
the grass or shrub shears.
2. Switch on the device:
Illustration I
a Press and hold the unlocking button of the ON/
OFF button.
b Press the ON/OFF button.
The device starts up.
The unlocking button of the ON/OFF button can
now be released.
To stop the device, release the ON/OFF button.
3. Cut bushes / hedges / shrubs with the shrub shears.
When cutting the hedge, keep the blades parallel to
the hedge.
Illustration R
Changing the grass and shrub shears
DANGER
Risk of injury due to cuts from sharp blades and ac-
cidentally switching on the device!
Make sure that the ON/OFF button is not pressed while
inserting the security key.
Avoid unintentionally switching on the device.
Wear safety goggles and protective gloves when work-
ing on the device. Always mount the blade guard before
working on the device and before transporting it.
1. Release the ON/OFF button.
The device switches off.
2. Remove the security key from the device.
3. Mount the blade guard on the grass and shrub
shears, see chapter Mounting the blade guard.
4. Remove the grass or shrub shears from the device:
Illustration S
a Press both release buttons simultaneously.
b Remove the grass or shrub shears from the
shear holder.
5. Mount the grass or shrub shears on the device:
Illustration D
a Insert the grass or shrub shears into the shear
holder as shown.
b Press the grass or shrub shears against the
shear holder until you hear them click into place.

Battery charging

● The LED indicator lights display the battery's current
charging state.
● All 3 LED indicator lights flash from bottom to top
when charging a completely empty battery.
● The lowermost LED lights up continuously when the
battery is 1/3 charged, the two upper LEDs continue
to flash.
● When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED con-
tinues to flash.
● After the battery has been fully charged, the 3 LED
indicator lights will continue to light constantly for 60
minutes. After this time, the LED indicator lights go
out.
Illustration G
1. Plug the charger into the mains socket.
2. Plug the charger into the charging socket.
1. Remove the security key.
2. Clean the device (see chapter Cleaning the device).
3. Oil the blades, see chapter Oiling the blades.
4. Mount the blade guard, see chapter Mounting the
blade guard.
CAUTION
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Release the ON/OFF button.
The device switches off.
2. Remove the security key from the device.
3. Mount the blade guard, see chapter Mounting the
blade guard.
4. Remove the grass or shrub shears from the device,
see chapter Changing the grass and shrub shears.
5. Before transporting the device with a vehicle, stow
or secure the device and the accessories so that
they will not slip or be thrown around when acceler-
ating, braking, cornering or in the event of an acci-
dent.
1. Release the ON/OFF button.
The device switches off.
2. Remove the security key from the device.
3. Clean the device, see chapter Cleaning the device.
4. Mount the blade guard, see chapter Mounting the
blade guard.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
ATTENTION
Risk of damage due to incorrect storage!
Incorrect storage can damage the device.
Store the device in a dry and well-ventilated interior
space.
Do not expose the device to direct sunlight for a long
time.
Keep the device away from corrosive substances such
as garden chemicals and de-icing salts.
5. Store the device in a dry, well ventilated interior
space.
English

Ending operation

Transport

Storage

21