Kärcher MIC 34C Betriebsanleitung Seite 53

8.13.5 Operation
DANGER
Risk of injury if you touch the rotating weed broom. Watch
for sufficient safety clearance to people when adjusting
and working.
Risk of injury on account of projected rocks or dirt. Correct-
ly adjust the spray guard and keep sufficient clearance to
persons.
DANGER
Accident risk on account of decreased steering perfor-
mance. When you press down on the weed broom, the
weight it taken off the front wheels. This can lead to a de-
screased steering effect. In this case, lift the weed broom
up immediately.
 The weed broom and the front appliance carrier are op-
erated using the joystick.
1 Bolt for transport lock
2 Spring pin
A Operation
B Transport
 Pull out the transport lock bolt.
 Swivel the front appliance carrier to the right.
 Insert the transport lock bolt into the operating position
and secure with spring cotter pin.
 Lower the front appliance carrier until the broom touch-
es the ground.
 Tighten the screw.
 Tighten the locknut.
 Start the motor.
 Raise the front appliance carrier.
 Roll (tilt at the side) the weed broom into the required
position, tilt it (forwards) and swivel it.
 For cleaning work, switch on the working hydraulics for
the main PTO. The weed broom rotates.
 Lower the front appliance carrier into the floating posi-
tion.
Note:
Usually, the front appliance carrier is lowered into the
floating position. If you desire an increased cleaning
performance, the weed broom can be briefly pushed
down.
 Perform cleaning process.
8.13.6 Joystick function
1 Joystick
2 Front button
3 Function keys
A - blue
B - red
C - green
D - grey
 The following are controlled with the joystick:
Implement frame
AUX 1 connection
AUX 2 connection
AUX connection, electrical 12 V
 When selecting a float position, the corresponding dis-
play lights up.
8.13.6.1 Operations
Front power lifter (with float position)
Main switch, float
position (console)
Activate
Front power lifter (without float position)
Main switch, float
position (con-
sole)
Deactivate
Weed broom arm (with float position)
Main switch,
float position
(console)
Activate
Press / lift the weed broom arm (without float posi-
tion)
Main switch,
float position
(console)
Deactivate
19
-
EN
Function button Joystick
Press the grey ---
button (D)
Function button Joystick
--- to the front / to the
rear
Function button Joystick
Press the green ---
button (C)
Function button Joystick
Press and hold move to the left /
right
53