Attachment Sets; Operations; Mower 125 Cm; Mower 135 Cm - Kärcher MIC 34C Betriebsanleitung

8

Attachment sets

In this chapter, a selection of the most common attach-
ment kits are listed and the attachment is shown on the de-
vice.
For further questions concerning other attachment kits,
please contact Kärcher.
Before installing and operating the attachment kit, be sure
to read the separate instructions and the safety instruc-
tions for the attachment kit.
WARNING
Rear attachments and load statuses have an impact on the
vehicle's centre of gravity and thus on the driving charac-
teristics.
In the case of modifications, particularly when converting
from winter to summer operation and in the case of
changeable load statuses, the driver must adjust to
changed driving characteristics.
Particularly when transporting fluids, additional surge
movements can occur which rock the vehicle.
8.1

Operations

 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.2

Mower 125 cm

8.2.1 Connecting the hydraulic lines
2
1 Hydraulic couplings main PTO
Hydraulic hoses, knife drive
2 Socket outlet E1
Cable for cutting height adjustment
8.2.2 Operations
 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.2.3 Prerequisites for operation
– The balance weight (option) must be attached to the
rear of the machine for driving on public roads.
– Set the motor rpm to high.
Note:
The wear on the ground can be reduced by using the up-
grade kit for grass tyres (2.851-089.0).
Removing the waste container/fresh water tank will in-
crease the driving stability and the driver's view.
8.2.4 After mowing
 Lower the working appliance and the suction opening.
 Clean the top surface of the suction opening with com-
pressed air (for sweepers).
 Clean the cooler.
8.3

Mower 135 cm

8.3.1 Connecting the hydraulic lines
1 Hydraulic couplings AUX2
1
Hydraulic hoses for rear ejector (marked with cable
ties)
2 Hydraulic couplings AUX1
Hydraulic hoses, cutting height
3 Hydraulic couplings main PTO
Hydraulic hoses, knife drive
8.3.2 Operations
 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.3.3 Prerequisites for operation
– The balance weight (option) must be attached to the
rear of the machine for driving on public roads.
– Set the motor rpm to high.
Note:
The wear on the ground can be reduced by using the up-
grade kit for grass tyres (2.851-089.0).
Removing the waste container/fresh water tank will in-
crease the driving stability and the driver's view.
8.3.4 After mowing
 Lower the working appliance and the suction opening.
 Clean the top surface of the suction opening with com-
pressed air (for sweepers).
 Clean the cooler.
13
-
EN 47