Wilo IL - E 50 / 10-36 xx Series Einbau- Und Betriebsanleitung Seite 29

LC display
4
5
6
The display returns to the basic setting
In the event of an error the error menu
r
Menu only appears under the chosen regulator mode control
system .
With ∆p-c and ∆p-v the menu jumps from
The following is valid for regulator mode control system:
Activate or deactivate ext. regulator mode.
Current setting blinks.
The other setting blinks.on:
on: activates external regulator mode (Fig. 7 a/b)
off: deactivates ext. regulator mode, the speed can be set on
the pump using the tuning button.
Setting stored.
t
Menü only appears under the chosen regulator mode control
system .
In regulator mode one can choose between two analog input signals:
Current setting blinks.
The other setting blinks.10V:
10V: activates external regulator mode via signal
0...10V (Fig. 7a).
20mA: activates external regulator mode via signal 4...20mA
(Fig. 7b).
Setting stored.
The following applies for all other modes:
The display shows „on off"
Switch pump on or off using the turning knob.
Setting stored.
w
.
o
appears before the basic setting
ENGLISH
Setting
e z
to
w
.
23