Trouble Shooting; Waste Disposal And Environmental Protection; Fault Correction - FLORABEST FHT 900 B3 Betriebsanleitung

Trouble Shooting

Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Possible cause
Mains voltage not on
On/Off switch (13) defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (13) defective
Blades (1) are blunt
Blades (1) are notched
Too much friction due to lack
of lubrication

Fault correction

Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
Have the blades (1) sharpened or
replaced (Service Centre)
Have the blades (1) checked or
replaced (Service Centre)
Oil the blades (1)
Electrical machines do not belong in
domestic waste.
Take the equipment to a waste disposal
site. The plastic and metal parts that are
used can be separated out into pure grade,
which allows recycling. Ask our Service
Centre for details.
GB
43